How to put on and adjust your dog’s harness

Follow the steps to put on your dog’s harness, adjust the straps, and check the fit. We’ll show you what to look for and what to do if you can’t get a comfortable fit.

When you first take the harness out of the package, all the adjustment points might feel a little confusing or intimidating. But once you’ve set them to fit your dog’s proportions, you usually only need occasional adjustments.

Start with the video guide

Watch how to put on and adjust your PETFORTA harness. You’ll find each step explained below.

Step 1. 

Adjust the shoulder straps.

First, gently guide your dog’s head through the harness. Feel for the bony point at the front of your dog’s chest (the breastbone), approximately where shown in the photo. Position the front triangle over this point.

The upper triangle should sit at the base of the neck, just in front of the shoulder blades, as shown in the photo. If both triangles are in the correct positions but the shoulder straps between them hang loose, shorten the straps to remove the slack.

Adjust both sides evenly. The left and right straps should be the same length so the harness sits symmetrically.

Step 2. 

Adjusting the back strap.

Adjust the back strap so that the chest straps sit over your dog’s rib cage, as shown in the photo. They should not sit over the soft belly area or directly against the armpits.

Shorten or lengthen the back strap until the chest straps are in the correct position.

Step 3. 

Adjusting the lower connecting strap.

Adjust the bottom strap using the same principle as the back strap: the chest straps should sit over your dog’s rib cage.

With your dog standing squarely, check the harness from the side. The chest straps should run vertically, perpendicular to the floor, as shown in the photo.

Step 4. 

Adjusting the chest fit.

Slide two fingers between the chest strap and your dog’s body, as shown in the photo. They should fit snugly without being forced underneath.

If there’s plenty of extra room around your fingers, tighten the chest straps. If it’s difficult to slide your fingers underneath, loosen them. Adjust both sides evenly.

Trouble getting the right fit?

If the harness slips to one side or twists

If the harness slips to one side, first check the symmetry: are the left and right sides adjusted evenly, and is the front triangle centered on your dog’s chest?

Next, check the snugness and the length of the bottom strap. Don’t tighten everything at once first, find where there’s excess slack.

If the straps twist, go through the adjustment steps again and make sure each strap lies flat without any twists.

This doesn’t necessarily mean the harness is the wrong fit. A few adjustments may be all it takes. If you’re still having trouble, we’re here to help.

If the harness seems too big

The harness isn’t adjusted to your dog straight out of the package. Before deciding whether the size is right, adjust all the straps, including the back and bottom straps.

If the straps are already at their shortest and the harness still fits too loosely, you may need a different size.

Not sure? Send us photos. We’ll help you check whether a few adjustments can improve the fit or whether a different size would work better.

If you’ve followed all the steps and still have questions about the fit, get in touch.

We’ll take a look at the fit and suggest what to adjust. You don’t have to figure it all out on your own.